Q-Lon Beige 96-Inch-Long Reach Kerf Weather Stripping Replacement for a Double Door

Will this fit my door?

Fits Taylor, Masonite, Therma-Tru, Jeld-Wen and other steel or fiberglass entry doors with a kerf-slot jamb (the thin groove the old seal pulls out of). Pull one end of your old seal out of the groove. If it comes out of a slot and the slot is about 1/8" wide, you have a kerf jamb and this seal presses straight in. No screws, no adhesive.

Long reach — about 5/8" to 3/4" of gap. Pick long if the old seal had a fat bulb or the door still rattles with a medium seal. If you are between sizes, go long — a seal that is slightly full compresses; a seal that is slightly short leaks.

Specifications

What's in the box

• (2) 96" medium-reach hinge-side seals
• (1) 96" long-reach lock-side (astragal) seal
• (1) 96" long-reach head seal

How to install

1. Open the door and pull the old seal out of the groove, starting at the top.
2. Press the new seal into the same groove, starting at the head and working down. Seat it with your thumb — it should sit flat with the bulb facing the door.
3. Trim the bottom flush with the sill using a utility knife. Close the door and check for daylight at the corners.

Cuts down easily for 30" and 32" doors. Replace the corner seal pads at the same time if yours are cracked or missing.

Related: all kerf compression weather stripping · magnetic weather stripping · corner seal pads · weather stripping guide

Not sure? Email a photo of your old seal to support@diydoorstore.com and we will match it.